There is no Internet connection after resetting the modem D-Link DSL-2740U modem settings

Hello, today I decided to update the firmware of my D-Link DSL-2740U router. Followed the instructions – reset the settings to factory defaults, pressed reset and …vam vam vam updated the firmware. And after that the Internet doesn’t work. Tried to put the connection WAN, no luck, writes connection failure and red light on the router, and was always lit green before. What to do?

Answer

Hello. As far as I know, you don’t need to do a factory reset to update the firmware. And the firmware upgrade process itself usually does not reset the settings. Maybe it’s different on D-Link DSL-2740U.

If your D-Link DSL-2740U doesn’t connect to the Internet, there is no connection, then the problem is definitely in the settings. I don’t know what firmware you have (by the look of it), but in any case, you need to configure your DSL-2740U to connect to the provider. After that, the indicator light that is red now will turn green. In the modem settings, on the “ADSL” or “Network” – “WAN” tab, you need to set the parameters that your ISP gives you. Login, password. Approximately like this:

Configuring the Internet on D-Link DSL-2740U