Netis router drops the IP address of the provider and does not determine before the reboot
Model Netis WF2880, firmware manufacturer’s latest version.
For a week already resets the connection to the Internet, dynamic ip address is not defined, can not be determined half a day, when rebooting and a possible connection immediately after the appearance of digits ip again reset.
At the router blinks SYS light, changed the socket, not reset to factory defaults, the router other did not try. My guess is that the chip in the router
- chip in the router
- Provider (whose community is pestiferous with anger customers last days about the loss of Internet) disconnects the connection itself, perhaps they are testing the technique of sovereign Internet.
Disconnects can stop for 3 or even 7 hours, but the question is why it is necessary to help the router to reconnect to the network, as even with availability itself it can not do it and can the provider signal (sounds ridiculous but still) rudely disconnect from the network with the above defects? Only PC is connected via cable, wifi only 2.4 hertz works (5 hertz disabled).
Response
I can’t be 100% sure, but I think in this case the problem is not the router.
Operators usually use L2TP connection type. There in the settings should be a username, password and server address. Connection type : Dynamic The only thing you can check is that the switch is set next to “Connect automatically”.
If the router sometimes connects to the ISP and gets an IP address, then you have everything set up correctly.
I think it’s some kind of problem on the ISP’s hardware side. Have you talked to their support about this problem?
The SYS indicator should be blinking.
Connecting devices to the router is irrelevant in this case, as the connection to the ISP is dropped on the router.
You have a PC. You can connect the Internet directly to it, configure the ISP connection and check how the Internet connection will work.
0
Ramón