Wi Fi distribution through a laptop in Windows 10 (via 3G/4G modem)
Hello! I created a virtual network for Wi-Fi distribution via com. line, everything is fine, configured, the network starts, Internet access is available. Problem: after each shutdown and turn on the laptop (network start as instructed through the com. line, the virtual network appears but without access to the Internet) have to go to the center for network management and shared access, go to the properties of the main Internet (3g to which we connect) checkboxes everywhere stand (created virtual network is prescribed) further: uncheck the box (Allow other users, etc.), click ok, the table comes out, click on the window, click on the checkbox, click on the window.etc., click ok, the table comes out, click ok, the window closes, then again enter the properties, access put the check mark in place, select virtual network, click ok, ok again, all, access to the Internet through a virtual network with Wi-Fi distribution appeared. (How to get rid of these manipulations?) With respect, Alexei.
Answer
Hello. I think it’s because of the peculiarities of your Internet connection. Although, when I configured it, the general access didn’t seem to fail, and everything worked. Anyway, there’s nothing you can do there, most likely.
Try running wifi sharing through a mobile hotspot.
Only one point, if you connect to the Internet through a program that was installed with a 3g/4g modem, then the mobile hotspot may not work.
In that case, you just need to set up the connection through the system.
0
Ramón